Hello,
I recently conducted an experiment which involved exposing participants to one-of-three conditions (see image).
When I have gotten round to analysing the data, I have been unable to find these conditions in the 'results' section, so can't split my participants to look at these differences.
I've probably gone terribly wrong somewhere down the road, would really appreciate some input!
Thanks, Lana
Userlevel 7
+27
@LMullins,
Based on your image, it looks like the three blocks you put under the randomizer were the same block, so in essence the randomizer didn't really serve any purpose and everyone saw the same question block. It seems like you should have had three different question blocks under the randomizer for the three different conditions.
Based on your image, it looks like the three blocks you put under the randomizer were the same block, so in essence the randomizer didn't really serve any purpose and everyone saw the same question block. It seems like you should have had three different question blocks under the randomizer for the three different conditions.
Hi Lana,
one thing you could do is to check in the "reports" what each of your participant saw. but in this way you have to go through each pp, hope you don't have many.
Best,
Kristina.
one thing you could do is to check in the "reports" what each of your participant saw. but in this way you have to go through each pp, hope you don't have many.
Best,
Kristina.
Leave a Reply
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.